Our annual or biannual preventative maintenance is a non-binding contract that each include our full array of benefits:
Maintenance Reminders
Lower Energy Bill
Priority Service
Peace of Mind
Check Refrigerant Levels
Check for Air Leaks
Check Thermostat setting
Clean Condenser Coils
Treat condensate drain
Change air filter (filter not included)
Check Blower Motor –measure amperage
Inspect for wear and lubricate any joints required
Inspect indoor coil
Inspect Condenser Coil
Safety Devices – inspect for proper operation
Electrical Disconnect Box – inspect for proper rating and safe installation
Test/inspect contactors for burned, pitted contacts
Inspect electrical for exposed wiring
Safety – test for proper operation
Inspect and test capacitors
Inspect fan blade
Inspect service valves
Measure Supply & Return temperature differential
Inspect ductwork for energy loss
Compressor – monitor and measure amperage
Check for Air Leaks
Check Thermostat
Change Air Filter (filter not included)
Check Burners & Flue Pipe
Check Gas Pressure – measure and adjust for peak efficiency
Check Refrigerant levels (Heat Pump)
Thermostat – test for proper operation, calibrate and level
Carbon Monoxide – test air flow duct system for dangerous carbon monoxide
Ignition System – test for safe and proper operation
Induced draft motor – test for proper venting
Measure Supply & Return temperature differential
Safety – test for proper operation
Inspect and adjust fan belt tension
Lubricate and clean blower motor
Burner – clean and inspect
Heat Exchangers – clean and inspect
Clean furnace exterior
Lubricate all moving parts required
Blower Motor – measure amperage and voltage for proper operation
Electrical Wiring – Tighten and inspect connections
Combustion Vents – clean and inspect
Natural Gas – check for leaks